RA-Studfix-V1-NM (Nursery School Model with lower screen height positions)

A complete Floor to Wall Mounting System suitable for Flat Screens with a maximum recommended weight of 65kg and maximum VESA mount configuration of 600x400, designed for use in Nursery and Primary School environments where a lower screen position is required. This Nursery Model allows the bottom of an average sized 65 inch screen to be positioned approximately 25cm from Floor Level.

A complete installation solution designed to enable Flat Screens or Touch Screens to be fixed to a wooden stud partition wall or solid wall and direct the weight of the screen directly to the floor. Ideal for installations when the wall itself cannot support the weight of a heavy screen.

The system includes two upright supporting box section legs which are fixed to the existing upright wooden studs inside the wall with a Wall Mounting Plate and Floor Plate included in the kit. This creates a rigid, safe and strong fixed mounting frame for the Flat Screen Mount (included) to fix onto and position the screen at a selection of height settings. All fixings, bolts, coach screws and plastic caps are included for a very neat and tidy installation.

The two Upright Supporting Legs are hollow box section design and allow all connection cables to and from the screen to be routed through them. Cable exit / entry slots are positioned on the inner sides of each leg to enable surface mounted cable trunking to route cables away to a connection panel if required (not included).

Maximum CENTRE POINT of screen from floor level is approximately 1060mm.

Minimum CENTRE POINT of screen from floor level is approximately 760mm.

The Wall Mounting Plate can be fixed to the wall in a LOWER or HIGHER position to avoid any dado rails or network trunking on the walls surface. In the LOWEST position the centre of the plate will be 650mm from floor level and in the HIGHEST position the plate will be 980mm from floor level. The Wall Mounting Plate itself is 120mm high and has four mounting slots 400mm apart. Upright supporting legs are 500mm apart (centre to centre). The maximum void between the wall plate and the rear of the upright legs is 65mm.

Full installation instructions included with each kit.

Finished in durable White or Black powder coat finish.

An Optional Extra Media Shelf is available for this system (RA-Studfix-Shelf) which can be positioned under the screen at a selection of height settings.